研究院科研情报与新闻主站科研动态 · 行业情报 · 管理政策
2026年11月17日
首页 › 碳纤维 › 正文

Flexible-chain architecture engineering of waterborne polyamic acid ammonium salt sizing agents for enhanced interfacial

Springer 2026-11-16 1 天前
performance of CF/PEEK composites ... · Volume 84, article number 34 (2027) ... Abstract Waterborne polyamic acid ammonium salt (PAAS) sizing agents with different flexible-chain architectures were designed to improve the interfacial performance of carbon fiber reinforced poly(ether ether ketone) (CF/PEEK) composites. Three representative PAAS systems containing cyclic, linear and hybrid flexible
performance of CF/PEEK composites · Original Paper · Published: · Volume 84, article number 34 (2027) · Cite this article Abstract Waterborne polyamic acid ammonium salt (PAAS) sizing agents with different flexible-chain architectures were designed to improve the interfacial performance of carbon fiber reinforced poly(ether ether ketone) (CF/PEEK) composites. Three representative PAAS systems containing cyclic, linear and hybrid flexible segments were synthesized and evaluated in terms of aqueous processability, coating behavior, thermal stability, interfacial characteristics and mechanical performance. The results indicate that flexible-chain architecture significantly influences the preparation route and interfacial reinforcement of the sizing agents. Cyclic-PAAS exhibited excellent aqueous processability through the conventional ammonium salt method, whereas Linear-PAAS required a semi-solvent strategy because of its hydrophobic long-chain aliphatic segments. Hybrid-PAAS achieved a favorable balance between aqueous processability and film-forming capability by integrating cyclic and linear flexible structures. During melt processing, the deposited PAAS layer was thermally converted into a continuous polyimide interphase, enhancing fiber/matrix compatibility and facilitating stress transfer. All three PAAS-sized CF/PEEK composites exhibited improved mechanical properties compared with the unsized control. The Linear-PAAS-sized composite achieved the highest tensile strength of 143.20 MPa, representing an increase of 17.18%. The Hybrid-PAAS-sized composite exhibited the highest elongation at break and impact strength of 12.47% and 22.75 kJ m⁻², corresponding to increases of 14.93% and 27.09%, respectively. Graphical abstract This is a preview of subscription content, log in via an institution to check access. Access this article Subscribe and save Springer+ from €37.37 /Month · Receive 10 units per month · Download 1 article/chapter for 1 unit · Get selected eBooks for 7 units · Cancel anytime Buy Now Price includes VAT (Hong Kong/P.R.China) Instant access to the full article PDF. Data availability No datasets were generated or analysed during the current study. References Periasamy K, Kandare E, Das R et al (2023) Interfacial Engineering Methods in Thermoplastic Composites: An Overview. Polymers. 15(2):415 Dabees S, Henderson L C, Hayne D J (2025) Carbon fibre surface modification and its effects on adhesion, mechanical, and tribological behaviour of high-performance thermoplastics. Compos Part B-Eng 306:112758-112758. Liu LT, Du MS, Liu F (2023) Recent advances in interface microscopic characterization of carbon fiber-reinforced polymer composites. Front Mater 10:1124338 Zheng H, Zhang WJ, Li BW et al (2022) Recent advances of interphases in carbon fiber-reinforced polymer composites: A review. Compos Part B-Eng 233 Yavuz Z, Öz Y, Ece RE et al (2025) Investigation of sizing materials for carbon fiber reinforced thermoplastic composites [J].Journal of Thermoplastic Composite Materials, 38(5):1799–1817 Hu JL, Yan F, Liu H et al (2021) Water-based PEKC-COOH sizing agent for enhancing the interfacial adhesion of carbon fiber/polyether-ether-ketone composites [J]. Compos Part B-Eng 225:109279 Lyu H, Jiang NY, Hu JQ et al (2022) Preparing water-based phosphorylated PEEK sizing agent for CF/PEEK interface enhancement. Compos Sci Technol 217:109096 Zhou N, Jia J, Zhao SY et al (2023) Interfacial enhancement of CF/PEEK composites by coating sulfonated PEEK sizing agent [J]. Surf Interfaces, 37:102652 Yan F, Yan T W, Wang GS et al (2024) A novel thermoplastic water-soluble sizing agent for the interfacial enhancement of carbon fiber/polyether ether ketone composites. Compos Part B-Eng 272:111205 Zhong SY, Dong ZX, Xiao YW et al (2025) The impact of crystalline PEEK sizing agent on the interfacial crystallization behavior and interfacial properties of carbon fiber reinforced PEEK composites. Composites Part B-Eng p 297 Wang SD, Yang YC, Mu YF et al (2021) Synergy of electrochemical grafting and crosslinkable crystalline sizing agent to enhance the interfacial strength of carbon fiber/PEEK composites. Composit Sci Technol p 203 Xu N, Chen SH, Li YZ et al (2022) A hybrid 1D/2D coating strategy with MXene and CNT towards the interfacial reinforcement of carbon fiber/poly(ether ether ketone) composite [J]. Composites Part B-Engineering, p 246 Guo JM, Pei W B, Dai ST et al (2024) Synergistic enhancement of interfacial adhesion for CF/PEEK composites through carbene chemistry and water-based self-catalyzed cross-linkable PENK-NH2 sizing agent [J]. Polym Compos 45(6):5320–5332 Zhang Q, Zu XJ, Ji XN et al (2025) Interfacial Improvement of Carbon Fiber/Poly (Ether Ether Ketone) Composites by Coating Water-Based Sulfonated Poly (Ether Ether Ketone) and Carbon Nanotube Composite Sizing Agent. J Appl Polym Sci 142(35) Qin CZ, Dai ST, Wang W et al (2025) Construction of a double-crosslinked interphase to optimize the interfacial properties of carbon fiber-reinforced polyether ether ketone composites. Composites Part a-Applied Science and Manufacturing, p 194 Li Q, Xie YJ, Hu XJ et al (2025) Bio-based hyperbranched poly (aryl ether ketone) sizing agent to enhance the interfacial property of carbon fiber/poly ether ether ketone composites [J]. Polym Compos 46:S444–S455 Ouyang XF, Ge GJ, Geng YZ et al (2024) Research on the effect of sizing agent on the interface and compression performance of carbon fiber composites. Front Mater 11:1437104 Song PF, Fang QL, Liu W et al (2024) Effects of Sizing Agents and Resin-Formulated Matrices with Varying Stiffness-Toughness Ratios on the Properties of Carbon Fiber Epoxy Resin Composites. Polymers 16(23):3447 Yang T, Zhao Y, Liu HS et al (2021) Effect of Sizing Agents on Surface Properties of Carbon Fibers and Interfacial Adhesion of Carbon Fiber/Bismaleimide Composites [J]. Acs Omega 6(36):23028–23037 Chen WT, Zhang K, Wang S et al (2025) Construction of rigid-and-flexible interphase by waterborne carboxylated polyimide sizing agent for interfacial enhancement of carbon fiber/poly ether ether ketone (CF/PEEK) composites. Composites Part B-Engineering, p 298 Chen WT, Zhang K, Wang S et al (2026) Construction of an interphase with heat and solvent resistance by a waterborne self-crosslinking polyamide-imide sizing agent to enhance the interfacial and mechanical performance of CF/PEEK composites. Composites Part B-Engineering, p 312 Jung H, Bae KJ, Oh Y et al (2023) Effects on the Thermo-Mechanical and Interfacial Performance of Newly Developed PI-Sized Carbon Fiber-Polyether Ether Ketone Composites: Experiments and Molecular Dynamics Simulations. Polymers 15(7):1646 Huang CY, Zhang P, Li B et al (2024) A Water-Soluble Thermoplastic Polyamide Acid Sizing Agents for Enhancing Interfacial Properties of Carbon Fibre Reinforced Polyimide Composites. Materials 17(11):2559 Huang CY, Sun JS, Liu ZW et al (2024) Enhanced Interfacial Properties of Carbon Fiber/Polymerization of Monomers Reactants Method Polyimide Composite by Polyimide Sizing. Materials 17(23):5962 Albayrak A, Dogu M, Cakir M et al (2025) Enhancing Interfacial and Mechanical Properties of Carbon Fiber/Poly (Ether Ether Ketone) Composites via Bisphenol-Based Polyimide Modification. Polymers 17(24):3258 Li YZ, Xu N, Lyu H et al (2023) Enhanced mechanical and tribological properties of carbon fiber/PEEK composites by hydroxylated boron nitride nanosheets and polyetherimide sizing agents. Compos Sci Technol 232:109851 Ren TN, Zhu GM, Zhang CS et al (2023) Preparation of CF/PEEK Composites with High Mechanical Performance Using PEEK Derivatives as the Sizing Agent. Macromol Rapid Commun 44(4):202200738 Ren TN, Zhu GM, Hou X et al (2021) Improvement of interfacial interactions in CF/PEEK composites by an s-PSF/graphene oxide compound sizing agent. J Appl Polym Sci, 138(45):51327 Ji XN, Ma HH Luol et al (2025) A novel high-temperature resistant Poly(arylene ether ketone) sizing agent containing graphene oxide: Achieve multiscale interfacial enhancement in CF/PEEK composites. Composites Science and Technology, p 271 Ding ZQ, Liu ZJ, Cao M et al (2026) Preparation and characterization of polyimide-modified carbon fiber-reinforced polyetheretherketone composites. J Thermoplast Compos Mater 39(8):4253-4273 Acknowledgements The authors thank the School of Materials Science and Engineering, Nanjing Tech University, for providing research facilities and technical support. Author information Authors and Affiliations College of Materials Science and Engineering, Nanjing Tech University, Nanjing, 211816, People’s Republic of China Zhenjie Xu, Xuanhao Zhang, Simiao Yu, Guangming Zhou, Tao Liu, Zhengyang Ji, Jie Liu & Gang Lu Contributions XZJ (First Author): Conceptualization, Methodology, Data Curation, Writing – Original Draft.ZXH: Formal Analysis, Validation, Visualization.YSM and JZY: Investigation, Raw Data Collection.LT , ZGM and LJ: Supervision.LG: Writing – Review and Editing. Corresponding author Correspondence to Gang Lu. Ethics declarations Competing interests The authors declare no competing interests. Additional information Publisher’s note Springer Nature remains neutral with regard to jurisdictional claims in published maps and institutional affiliations. Rights and permissions Springer Nature or its licensor (e.g. a society or other partner) holds exclusive rights to this article under a publishing agreement with the author(s) or other rightsholder(s); author self-archiving of the accepted manuscript version of this article is solely governed by the terms of such publishing agreement and applicable law. About this article Cite this article Xu, Z., Zhang, X., Yu, S. et al. Flexible-chain architecture engineering of waterborne polyamic acid ammonium salt sizing agents for enhanced interfacial performance of CF/PEEK composites. Polym. Bull. 84, 34 (2027). https://doi.org/10.1007/s00289-026-06762-2 Received: Revised: Accepted: Published: Version of record: DOI: https://doi.org/10.1007/s00289-026-06762-2 Keywords Profiles · Gang Lu
原文出处:https://link.springer.com/article/10.1007/s00289-026-06762-2
提示:本站仅汇集公开信息,版权归原作者与原发布媒体所有。
P204 · P204-2